Assembly Instruction - POWER SMITH PLV6000A Manual Del Operario

ASSEMBLY INSTRUCTION

SETTING UP AND BREAKING DOWN THE LIGHT (FIG 2)
Your work light is fully assembled and ready to use out of box.
To Set Up the Light:
From folded position A to working position D.
1. Unwrap the power cord (13).
2. Release the leg locking clip (10). See position A.
3. Expand the tripod legs (11) and then lock the leg locking clip. See
position B.
4. Place the light head locking button (2) in Unlock position, then flip
the light heads (1) up. See position C.
5. Release tripod locking clips (7), raise the tripod (8) and lock the
tripod locking clips. See position D.
6. Adjust the light heads (1) to be desired position.
To Break Down the Light:
1. Release the tripod locking clips (7), lower tripod all the way down
and lock the tripod locking clips.
2. Fold the light heads (1) down in a tube shape.
3. Release the leg locking clip (10).
4. Raise the leg connector (9) until the light heads nest inside.
5. Lock the leg locking clip.
6. Wrap the power cord.
You may also refer to "QUICK START GUIDE" sheet which comes with the product.
ON-BOARD SWITCH
Your light has a red on-board switch (5-FIG1). See Figure 1 for its location. This switch turns the light On and Off and
controls the light mode. The light mode rotates in the following sequence by each press on the switch:
Work Light - Night Light - Flashing Alert Light - OFF
The switch has a delayed "OFF" function. If a light mode stays on for more than 15 seconds, the next press on the
swich will turn off the light.
REMOTE CONTROL (FIG 3)
Your light includes a remote control PARC23 (6-FIG1). It docks in the middle of the
tripod pole.
There are two buttons on the remote control. The top one (A) is to turn the light On
or Off. The bottom one (B) is to select the light mode among Work Light, Night Light
and Flashing Alert Light.
Slide the remote control up to take it off the holder. Always keep it in the holder
when not in use.
The maximum control range is approximately 60 feet from the light.
The remote control is powered by a 3V Lithium-Ion button battery CR2032L.
Remove the four screws on the back cover to replace the battery.
WARNING:
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
English
From postion D back to position A.
OPERATION
This device complies with part 15 of the FCC Rules. Operation is subject to the
4
A B
C D
FIG 2
A
FIG 3
B