Assembly Instruction - POWER SMITH PWL2160TS Manual Del Operador

ASSEMBLY INSTRUCTION

ADJUSTING THE TRIPOD (FIG 2)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B) are fully extended
and firmly tighten the locking knob (F).
3. Adjust the height of the tripod by loosening the twist collars (C1 &
C2) and raising the center poles (D1 & D2) of tripod. Firmly tighten
the twist collars when the tripod reaches desired height.
NOTE
: The maximum height of this tripod is 64".
4. Loosen the twist collar (C3) and adjust the extendable leg (B2) to
level the tripod on uneven surfaces. Tighten the collar (C3) after
leveling.
ATTACHING CARRYING HANDLE TO
STAND (FIG 2)
1. Place the carrying handle (1) vertically on the stand (7).
2. Use two hex screws (10), flat washers and spring washers to secure
the carrying handle on the stand as shown in FIG 2.
ATTACHING WORK LIGHT HEADS TO
STAND (FIG 2, 3)
1. Place the stand (7) on a flat surface.
2. Use the locking knobs (8), flat washers and spring washers to
secure both work light heads on the sides of the stand as shown in
FIG 2.
3. Use a twist knob (12) to attach the power cable connector (13) to
the carrying handle as shown in FIG 3.
ATTACHING THE WORK LIGHT
ASSEMBLY TO THE TRIPOD (FIG 2, 4)
1. Place the work light assembly on top of the tripod. Insert the bottom
ends of the two Hex screws (10) into the two holes on the supporting
bracket (E).
2. Use the bracket locking system (E1, E2 and E3) to secure the work
light assembly to the tripod as shown in FIG 4.
English
All manuals and user guides at all-guides.com
4
2
8
E1
7
E2
E3
A
B
F
FIG 2
1
13
12
FIG 3
E1
1
2
8
10
E
D2
C2
D1
C1
B
C3
B2
E2
E3
FIG 4