LG Signature LUPXS3186N Manual Del Propietário página 62

62 TROUBLESHOOTINg
Problem
Pulsating or Your refrigerator is designed
High-Pitched to run more efficiently to keep
Sound your food items at the desired
temperature. The high efficiency
compressor may cause your
new refrigerator to run longer
than your old one, but it is still
more energy efficient than
previous models. While the
refrigerator is running, it is
normal to hear a pulsating or
high-pitched sound.
Doors will not Food packages are blocking the
close correctly or door open.
pop open.
Ice bin, crisper cover, pans,
shelves, door bins, or baskets
are out of position.
The doors were removed during
product installation and not
properly replaced.
Refrigerator is not leveled
properly.
Doors are difficult The gaskets are dirty or sticky.
to open.
Door was recently closed.
InstaView™Door- Knocking too softly or on edges
in-Door® panel of panel. Loud noise near
doesn't work refrigerator.
properly.
Auto Open Door Motion sensor not activated or
does not work flooring material too reflective.
properly.
Auto Open Door not open wide enough.
Drawer does not Closing door too quickly.
work properly.
Possible Causes Solutions
Normal Operation
Rearrange food containers to clear the door and
door shelves.
Push bins all the way in and put crisper cover,
pans, shelves and baskets into their correct
positions. See the Using Your Refrigerator section
for more information.
Remove and replace the doors according to the
Removing and Replacing Refrigerator Handles
and Doors section.
See Door Alignment in the Refrigerator Installation
section to level refrigerator.
Clean the gaskets and the surfaces that they
touch. Rub a thin coat of appliance polish or
kitchen wax on the gaskets after cleaning.
When you open the door, warmer air enters the
refrigerator. As the warm air cools, it can create
a vacuum. If the door is hard to open, wait one
minute to allow the air pressure to equalize, then
see if it opens more easily.
Knock twice near the center of the glass panel.
Tap hard enough so the taps are audible. Loud
noises may activate InstaView™ function. The
LED turns off automatically after 5 seconds.
Make sure your foot passes in front of the motion
sensor before you step on the displayed text. If
the flooring material is highly reflective, the Auto
Door sensor may malfunction.
Open the door at least 85 degrees. Close the door
to less than 85 degrees, then allow the sensor to
react and the drawers to close before fully closing
the door.