General Safety Precautions - entrematic Ditec OBBI Manuale Tecnico

1. General safety precautions

This installation manual is intended for qualified personnel only.
Installation, electrical connections and adjustments must be performed in ac-
cordance with Good Working Methods and in compliance with the present standards.
Read the instructions carefully before installing the product.
Bad installation could be dangerous.
The packaging materials (plastic, polystyrene, etc.) should not be discarded in
the environment or left within reach of children, as these are a potential source
of danger.
Before installing the product, make sure it is in perfect condition.
Do not install the product in explosive areas and atmospheres: the presence of inflam-
mable gas or fumes represents a serious safety hazard.
Before installing the motorisation device, make all the necessary structural modi-
fications in order to create safety clearance and to guard or isolate all the crushing,
shearing, trapping and general hazardous areas.
Make sure the existing structure is up to standard in terms of strength and stability.
The motorisation device manufacturer is not responsible for failure to observe Good
Working Methods when building the frames to be motorised or for any deformation
during use.
The safety devices (photocells, safety edges, emergency stops, etc.) must be installed
taking into account: applicable laws and directives, Good Working Methods, installa-
tion premises, system operating logic and the forces developed by the motorised door.
The safety devices must protect the crushing, cutting, trapping and general
hazardous areas of the motorised door.
Display the signs required by law to identify hazardous areas.
Each installation must bear a visible indication of the data identifying the motorised
door.
When requested, connect the motorised door to an effective earthing system that
complies with current safety standards.
During installation, maintenance and repair operations, cut off the power supply before
opening the cover to access the electrical parts.
The automation protection casing must be removed by qualified personnel only.
The electronic parts must be handled using earthed antistatic conductive arms.
The manufacturer of the motorisation declines all responsibility in the event
of component parts being fitted that are not compatible with the safe and correct
operation.
Use original spare parts only for repairs or replacements of products.
The installer must supply all information on automatic, manual and emergency opera-
tion of the motorised door and must provide the user with the operating instructions.
26