entrematic Ditec OBBI Manuale Tecnico página 33

- Fix the tail bracket [14], respecting measurements [A] and [B] on the basis of the desired
opening angle [D].
On the tail bracket there are holes that facilitate the assembly operation.
- Fix the piston to the rear bracket [14] with the pin [F] supplied.
- Extend the haulage tube completely [11] to its maximum length, then shorten it by approximately
20 mm.
WARNING: the stops must keep a 10 mm margin of tube stroke, in both the door wing closed
and door wing open positions.
- With the gate completely closed, position the front bracket [15], check it is aligned with the
rear bracket and fix it to the gate.
- Fix the piston to the front bracket with the pin [G] supplied. To work correctly, the gearmotors
must be assembled with the motor casing at the top.
- Unblock the gearmotor and check (moving the gate manually) the entire stroke is free of
interference. Slightly lubricate the front and rear articulated joints.
G
15 11
F
14
33
16