Horizon Fitness HT5.0 Manual Del Usuario página 5

A Open HARDWARE FOR STEP 1. Remove outer packaging.
1
B Attach BASE FRAME (2) to MAIN FRAME (1) using 4 BOLTS
(A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C)
from the top and 2 longer BOLTS (E), 2 SPRING WASHERS
(B) and 2 FLAT WASHERS (C) from the bottom.
C Insert 2 BOLT COVERS (D) as shown.
D REQUIRES 2 PEOPLE: Lift and tip MAIN FRAME (1) into
upright position. Remove STYROFOAM BLOCKS (3).
Hardware For Step 1
Description Qty
A Bolt (55 mm) 4
B Spring Washer 6
C Flat Washer 6
D Bolt Covers 2
E Bolt (65 mm) 2
1 D A B C 2
C
A B C
4
3
A Open HARDWARE FOR STEP 2.
2
B Attach CRANK ARM (5) to UPPER LINK ARM (6) using
1 BOLT (F), 2 FLAT WASHERS (C) and 1 NUT (G).
C Attach the front of FOOT PAD (8) to UPPER LINK ARM (6)
using 1 BOLT (H), 2 FLAT WASHERS (I) and 1 NUT (J).
D Attach the rear of FOOT PAD (8) to LOWER LINK ARM (7)
using 1 BOLT (K), 2 FLAT WASHERS (I) and 1 NUT (J).
E Repeat on other side.
Hardware For Step 2
Description
F Bolt (50 mm)
C Flat Washer (M8)
G Nut (M8)
H Bolt (130 mm)
I Flat Washer (M10)
J Nut (M10)
K Bolt (100 mm)
B E
Remove
twist ties
Qty
2
4
2
2
8
4
2
8
J
F C
5
G
I
6
H
7
K
5