Sharpening The Cutting Blade - Ego Power+ HT2400 Manual De Funcionamiento

WARNING:
when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents. Use clean clothes to remove dirt, dust, oil, grease, etc.

SHARPENING THE CUTTING BLADE

1. Start and stop your hedge trimmer
until the cutter blade and the guard are
slightly offset, as shown in Fig. 9. This
will allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from you
hedge trimmer.
3. Clamp the blade assembly in a vise
and file the exposed cutting surface
of each blade tooth. Remove as little
material as possible. Be sure to retain
the original angle of each tooth when filing.
4. Remove the hedge trimmer from the vise; restart it and stop it to expose the
unsharpened edges of the blade teeth.
5. Remove the battery pack and repeat the sharpening procedure above.
NOTE:
Do not operate your hedge trimmer with dull or damaged cutting blades.
This may cause overload and will give unsatisfactory cutting results.
Never use water for cleaning your trimmer. Avoid using solvents
56V LITHIUM-ION CORDLESS HEDGE TRIMMER
9
Cutter Tooth
Guard Tooth
21