Troubleshooting - Silverline 268895 Traducción Del Manual Original

GB

Troubleshooting

Problem
Red and green LEDs do not
illuminate to indicate the battery is
correctly charging
Battery pack has low capacity
Impact Driver cannot be switched on
(Trigger Switch (10) does not move)
Impact Driver does not start when
Trigger Switch is depressed
8 8
Possible cause
Battery not correctly connected to charger
Charger not powered
Battery not being fully charged
Battery pack has been charged over 100 times and capacity
has started to reduce
The Forward/Reverse Switch may be in the middle ('locked')
position
Battery completely discharged
Defective battery
Tool defective
Solution
Clean battery socket of charger and battery contacts and fully slide on to charger so
it clicks in a locked position
Recheck mains connection
Do not remove battery until a full charge is indicated
This is normal for battery packs. Contact your Silverline dealer to purchase a
replacement battery pack
Slide the Forward/Reverse Switch either to the left or right
Recharge battery or replace with a fully charged battery
Replace battery
Contact your Silverline dealer or authorised service centre