Tabla de contenido
Publicidad
OPTIONAL: EXTEND THE ARMS
Some vehicles may have interference issues
with certain EXO Accessories installed on EXO
TopShelf™, in which case you will need to change
the EXO TopShelf arms to the outer position.
A. Using a 5 mm hex wrench and 8 mm box
wrench, remove the 2 bolts, washers, and
nuts on each arm.
B. Slide the arms out.
C. Reinstall the bolts, washers, and nuts, and
fully tighten to 8 Nm.
B
8 Nm
Visit Yakima.
com or your
preferred dealer
to purchase or
research these
accessories.
EXO BackDeck™
Instruction #1036039A - page 6 of 10
A
C
RECOMMENDED ACCESSORIES
EXO GearWarrior™
EXO SnowBank™
NOTE: Remove accessories from EXO TopShelf™
before uninstalling.
A. Open the driver-side arm of the EXO SwingBase™.
B. Remove bolts and washers. Lift from EXO SwingBase.
C. Reinstall the cap onto EXO SwingBase.
D. Store EXO TopShelf in a safe place.
WARNING
When using EXO TopShelf
with EXO DoubleUp
ensure there is at least 13"
between the handlebars of
the inner bike and the rear
of your vehicle.
13" (33 cm)
B
• Attachment hardware can loosen over time.
Check and tighten if necessary, before each use.
• Be sure all hardware is secured according to
instructions. Failure to perform safety checks
before driving away can result in property
damage, personal injury, or death.
EXO WarriorWheels™
EXO DoubleUp™
REMOVAL
IMPORTANT!
™
™
,
Be sure to read all
the warnings and
warranty information
contained in the
insert accompanying
these instructions!
WARNING
EXO GearLocker™
Publicidad
Tabla de contenido
