Setting The Depth Gauge; Dressing The Wheel For Depth Gauges - Oregon 511A Manual De Instrucciones

Figure 26
Figure 27
E. Setting the Depth Gauge:
1. Set grinder head angle at 60
28). Install the 1/4" wheel. Set vise angle
to 0 O (see Figure 29).
Figure 28
O P E R A T I N G I N S T R U C T I O N S
Figure 29

2. Dressing the Wheel for Depth Gauges.

Figure 30
O (see Figure
Place dressing brick #9 level on top of
chain vise, then lower the wheel onto the
grinding brick. Grind surface until shape
for wheel is parallel with chain vise (see
Figure 30).
Note: When dressing the grinding wheel,
use intermittent strokes. Using steady pres-
sure on dressing brick can cause it to burn
and shorten the life of the brick.
0
13