Setting Vise Tilt Angle - Oregon 511A Manual De Instrucciones

Figure 15
4. To set right-hand cutter top-plate grind
angle, rotate vise assembly to left of center
(O O ) (see Figure 17). (See page 15 for cor-
rect degree setting of different chain types.)
5. Setting vise-tilt angle. The cutting chain
vise assembly has a tilting feature, (see
Figure 18), that is used to control the side
plate hook angle on some chains. Use cen-
ter mark for chains requiring 90
chains requiring 10
6. Tilt vise to INWARD position for left-
hand cutters (see Figure 19).
7. Tilt vise to OUTWARD position for right-
hand cutters (see Figure 20).
Figure 16
Figure 17
O P E R A T I N G I N S T R U C T I O N S
O (for those
O tilt see page 15).
Figure 18
Figure 19
Figure 20
11 0