Servicing The Hydraulic System - Oregon 511A Manual De Instrucciones

0
14
Figure 31
3. Setting The Chain Stop. Position the cut-
ter's depth gauge so that it is centered
under the grinding wheel (see Figure 31).
Use chain-stop adjusting knob to obtain
this setting (see Figure 32).
Figure 32
4. Setting the Depth Gauge. Place an ORE-
GON ® Gaugit (depth gauge setting tool) on
the chain in vise over the depth gauge por-
tion of the cutter (see Figure 33).
Note: Gaugit not included. See
page 15 to locate the correct depth gauge
tool for chain type.
O P E R A T I N G I N S T R U C T I O N S
Figure 33
Figure 34
5. With an OREGON
6. Grind all depth gauges.
® flat file
(P/N 12211), file the first depth gauge.
Note: OREGON® flat file P/N 12211
not included.
Remove the gaugit and lower the grinding
wheel so that it touches the portion of the
depth gauge that has just been hand filed.
Set the depth adjustment knob and lock
into place. This has just set the depth of
grind surface for the rest of the depth
gauges.