Vimar ELVOX EKKO 204D Manual Para El Conexionado Y El Uso página 17

EKKO
Now the gearmotor is unlocked and you can open and close the gate leaf manually. Check with some complete movements that the fork runs smoothly along
its full travel.
Adjusting the mechanical limit stop:
In the bottom of the gearmotor there are two mechanical stops, one for stopping the gate leaf on opening and one for closing. With the gate leaf unlocked,
move the gate leaf into the required open position, loosen the mechanical stop A and take it to rest on the pin.
Move the gate leaf into the closed position, loosen the mechanical stop B and take it to rest on the pin.
Check with some manual opening and closing movements that the gate leaf stops at the correct point.
A
Electrical connection of the gearmotor: the connecting cable to the control unit must have a sufficient curvature to follow the movement of the gearmotor
during operation. Unscrew the cable grommet P, insert the cable through the gearmotor, and then lock the cable grommet.
Make the connections on the terminal as indicated, respecting the connections shown.
Description of electrical connection:
NB: the cable connecting the encoder to the control unit must not exceed 10 m in length. For lengths of wiring encoders exceeding
10 m but not exceeding 15 m you must use a shielded cable
EN
B
1 OPEN
2 CLOSE
3 Encoder +
4 Encoder S
5 Encoder -
15