Parkside PGG-30 Instrucciones De Utilización Y De Seguridad página 27

If the electrical cord becomes damaged,
it must be replaced with a special cord.
These are available from the manufacturer
or authorised customer service.
This device is not intended for use by
people (including children) with limited
physical, sensory or mental capacity
or those who lack experience and/or
knowledge.
Children should be supervised to ensure
that they do not play with the device.
WARNING! This tool must be kept on its
stand when not in use. Fire hazard!
Before using the device
Use of this device may result in injury and
property damage through fire or electric
shock. Before using the device, you must
therefore check the following: Make sure
that the voltage listed on the glue gun
corresponds to the voltage of the power
supply.
• Make sure that the electrical cord (11)
and plug are in proper condition: The
cord and plug must be of the proper
size and intended for the purpose; the
cord must not be tangled or damaged.
• Do not use an extension cord that is
longer than necessary for the intended
use!
• Never lock the feed switch in place.
• Do not use the device in damp
surroundings.
While using the device
The metal glue nozzle gets hot. Be careful
not to touch the glue nozzle. Burn hazard!
Never leave the device unsupervised when
turned on. Fire hazard!
Always use caution when working. Molten
glue is hot and can cause painful burns
to the skin. Due to its viscosity, hot glue
cannot be removed from the skin quickly.
If you cannot prevent contact with molten
glue, rinse the affected areas of the skin
with cold water. This hardens the glue
immediately and helps to limit the effect of
the burn.
Electrical safety
When using electrical devices, adhere to
all locally applicable safety regulations
regarding the risks of fire, electric shock
and injury. Inform yourself of and conform
to those regulations as well as the
instructions provided here.
Always check to see whether your
electrical voltage corresponds to
that shown on the model
designation label.
Protection Class II device –
insulated – no ground contact
necessary.
Replacing cables or plugs
If the electrical cord becomes damaged,
it must be replaced with a special cord.
These are available from the manufacturer
or authorised customer service. Dispose
of old cords or plugs immediately after
replacing them with new ones. It is
dangerous to insert the plug from a loose
or damaged cord into an electrical outlet.
Using extension cords
Only use a suitable, certified and
appropriately marked extension cord that
corresponds to the device rating. The core
must be at least 1.5 mm in diameter. If the
cord is on a reel, it must be fully unwound.
Safety instructions
GB/MT 27