Levenhuk D80L Guía De Usuario página 9

View photos and videos
1. Insert the SD card into the SD slot.
2. Press the "Video" button twice to turn on the viewing mode.
3. Press the "Right" and "Left" buttons to view the pictures and videos. Press the "Capture" button to start playing the video.
Save photos and videos on a computer
1. Insert the SD card into the SD slot.
2. Use the USB cable for connecting the microscope to the computer. Now, you can transfer the photos and videos to a
computer.
View on a computer (Windows 7 and below only)
1. Install the SENSor driver software on the computer (included). The CamApp icon will appear on your desktop after the
installation of the software is complete.
2. Use the "Power on/off" button to turn off the LCD screen.
3. Use the USB cable for connecting the LCD screen to the computer.
4. Press and hold the "Photo" button until PC CAM appears on the LCD screen. Then, the driver installation will start
automatically.
5. When the installation is complete, click the CamApp icon on your computer's desktop to start viewing.
Connecting to a TV/monitor with an AV connector
1. Use an AV cable (not included) for connecting the LCD screen to the TV/monitor.
2. Press the "Setup" button.
3. Select the TV OUT menu item.
4. Select TV mode (NTSC/PAL).
5. Now, you can start viewing on the screen.
Setup
Press the "Setup" button to go to the settings menu of the LCD screen. Use the control buttons to select the required
parameters. Press the "Setup" button again to save the selected parameters.
Hold the "Power on/off" button for 3 seconds to turn the LCD screen off.
Fuse replacement (Levenhuk D90L LCD)
Unplug the microscope from a power source. Open the fuse holder located on the back of the microscope body with a flat head
screwdriver. Remove the old fuse and install a new one. Only use the appropriate types of fuses. Close the fuse holder.
9