GMC GMBL18CH Traducción Del Manual Original página 10

• Prior to drilling large holes, use a smaller bit to drill a pilot hole
• Use a suitable coolant/lubricant to prolong the service life of the drill bit, and produce
good results
Drilling masonry
• 'Hammer drill mode' should be used for drilling into masonry and concrete
• Always use a masonry drill bit, preferably a TCT masonry bit, when drilling into walls,
stone or concrete
• DO NOT apply too much pressure to the back of the tool. If debris blocks the drill hole,
run the drill slowly and remove the bit from the hole. Repeat until the hole is clear of
debris and continue
GB
Accessories
• A range of accessories, including including additional batteries as well as drill and
screwdriver bits, is available from your GMC dealer. Spare parts can be purchased from
your GMC dealer or online at www.toolsparesonline.com
Maintenance
• This tool is manufactured using class-leading components and makes use of the latest
in intelligent circuitry that protects the tool and its components. In normal use it should
provide a long working life
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the machine's service life. Clean the body of your machine with a
soft brush or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out of the
reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
10