Playcore Swing-N-Slide 5' Turbo Tube Slide Instrucciones De Montaje página 11

Fig. 4c
Flange Opening
Slide Elbows
1. Align third elbow so that Hole #1 aligns with the
flange opening as shown in (Fig. 4) and
(Fig. 4c) and secure in place.
2. Align fourth elbow so that Hole #1 aligns with the
flange opening, as shown in (Fig. 4b) and
(Fig. 4c) and secure in place.
NOTE: Interlocking design of flanges on Elbow
pieces will assist in assembly.
NOTE: Hand tighten the loc nuts only.
Elbow Section - 12 bolts
Hole #1
Fig. 4
Hex Head Bolt
11
ssembly Instructions
Fig. 4a
Washer
Washer
Loc Nut
Fig. 4b
Elbow Section - 12 bolts