Playcore Swing-N-Slide 5' Turbo Tube Slide Instrucciones De Montaje página 17

Fig. 10
FIGURE 14
2" x 4" x 8-1/4"
2" x 4" x 18"
2-1/2" Screws
Pre-Drill
FLUSH
2'' Lag screw
2-1/2'' screw
2" x 4" x 11-1/4''
2" x 4" x 18"
2-1/2" Screws
2" x 4" x 8-1/4"
Fig. 10a
(2) 2" Lag Screws
Support Bracket
17
ssembly Instructions
SUPPORT ND BR CKET
SSEMBLY
1. Assemble the support base as shown in (Fig. 10).
2. Attach the support bracket to the support base using
two lag bolts (Fig. 10a).
NOTE: Pre-drill 1/8" pilot holes.
3. Place the support beneath the Exit and determine its
final position. NOTE: Slide support should fit tightly
beneath the slide to assure proper support. Remove
corresponding nut and bolt, attach support to the slide
as indicated in (Fig. 10b). Re-attach hardware.
4. Level grade at the bottom of the slide.
Fig. 10b
Loc Nut
Washer
Hex Head
Bolt