Playcore Swing-N-Slide 5' Turbo Tube Slide Instrucciones De Montaje página 8

ssembly Instructions
Fig. 1
Entrance Bracket
ENTR NCE SECTION
NOTES:
• At least two individuals are needed to assemble the 5' Turbo Tube Slide.
• To aid in aligning holes when assembling sections, insert a screwdriver through adjacent holes to maintain hole
alignment.
1. Assemble the Entrance Section by securing the top seam first, as shown in (Fig. 1) and (Fig. 1a). Join sections using a
hex head bolt, two flat washers, and a loc nut at each hole junction.
2. When securing the bottom seam make certain to attach the Entrance Bracket to the left side of the seam as shown in
(Fig. 1) securing in place as shown in (Fig. 1a).
3. Tighten all hardware.
SSEMBLY
Hex Head Bolt
Washer
Entrance Section - 8 bolts
8
Fig. 1a
Washer
Loc Nut