Playcore Swing-N-Slide 5' Turbo Tube Slide Instrucciones De Montaje página 16

ssembly Instructions
Fig. 9a
(1)
2'' screw
per side
Fig. 9
FlUSH
Fig. 9b
(2)
2'' lag screws
(2)
5/16'' Flat
Washers
FlUSH
(12)
2'' lag screws
2'' x 4''
16
bRACKET SHOUlD bE TIGHT
AGAINST 2'' x 4''
UNDER DECK VIEW
5/16'' Flat Washer
2'' Lag screw
1-1/4'' Lag screw
2'' screw
Slide Installation
1. Lift and attach 5' Turbo to units, as shown in
(Fig. 9).
Note: Two people will be required to properly
align the Turbo Tube Slide with your tower.
2. On either side of the Slide Entrance there is a
dimple. Insert (1) 2'' Screw in either side, so
that the screw goes into the support board
behind, as shown in (Fig. 9a).
3. Secure Elbow Bracket to 2'' x 4'' as shown in
(Fig. 9b).
Note: The lower edge of the Elbow Bracket
must sit tightly against the top of the 2'' x 4''
support board.
Approximate
1-1/4''
Gap
(2)
1-1/4'' lag screws