Black+Decker BDCMS20 Manual Del Usuario página 9

FINGER ATTACHMENT (FIG. D -
OPTIONAL ACCESSORY)
The finger attachment is used for fine detail
sanding.
• Remove the screw (10).
• Remove the diamond-shaped pad tip
(11) from the base.
• Fit the finger attachment (6) onto the
sanding base as shown in Figure E.
• Fit and tighten the screw.
• Align the appropriate sanding sheet with
the finger attachment.
E
6
REPLACING DIAMOND SHAPED
TIP (FIG. F)
• Replace the diamond shaped tip (11).
• Replace and tighten screw (10).
F
FITTING AND REMOVING THE
DUST CANISTER (FIG. G)
CAUTION:
To reduce the risk of injury,
turn off and remove the battery from the tool
before making any adjustments or removing
or installing attachments or accessories.
CAUTION:
Respiratory hazard. Never
operate this tool for wood sanding unless
the dust canister is in place. Sanding dust
exhaust may create a breathing hazard.
WARNING:
Fire hazard. Collected
sanding dust from sanding surface coatings
(polyurethane, linseed oil, etc.) can self-ignite
in sander dust canister or elsewhere and
cause fire. To reduce risk, empty canister
frequently and strictly follow sander manual
10 11
and coating manufacturer's instructions.
WARNING:
working on metal surfaces, do not use the
dust canister or a vacuum cleaner because
sparks are generated. Wear safety glasses
and a dust mask. Due to the danger of fire,
do not use your sander to sand magnesium
surfaces. Do not use for wet sanding.
• The dust collection canister (4) should be
emptied after every 10 minutes of sanding.
• Slide the dust canister (4) onto the
connector (4a) and make sure that it is
securely located.
• To remove the dust canister, pull it to the
rear and away from the rear end of the tool.
G
4a
HINTS FOR OPTIMUM USE
WARNING:
own pace. Do not overload.
• Do not place your hands over the
ventilation slots.
• Do not exert too much pressure on the tool.
• Regularly check the condition of the
sanding sheet. Replace when necessary.
• Always sand with the grain of the wood.
• When sanding new layers of paint before
applying another layer, use extra fine grit.
• On very uneven surfaces, or when
removing layers of paint, start with a
coarse grit. On other surfaces, start with
a medium grit. In both cases, gradually
change to a fine grit for a smooth finish.
• When sanding on a vertical surface, hold the
back handle (2) for better grip and control.
ACCESSORIES
A variety of Mouse
available at extra cost. Listings per retailer
may vary. Note: Use only sandpaper with
holes in the same configuration as on the
base of the sander. Sandpaper without
holes will not allow dust to enter the
canister.
The hook and loop pad and individual
bases are replaceable parts. If they
become worn, contact your local service
center. For more information call: 1-800-
544-6986.
WARNING:
not recommended for use with this tool
could be hazardous.
9
Fire hazard. When
4
Let the tool work at its
accessories are
®
The use of any accessory