Rowenta ECO INTELLIGENCE DW6000 Instructivo De Operación página 11

Ocultar thumbs Ver también para ECO INTELLIGENCE DW6000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1103908343-index 01 DW6000 US_110x154 17/11/11 10:24 Page5
Wait a few seconds between each shot before pressing the button again.
IMPORT NT Never direct the steam at persons or animals!
8 • Spray
Press the spray button
9 • nti-Drip system*
This prevents water escaping from the soleplate when the temperature is too low.
10 • utomatic electronic 3-position shut-off*
If, although switched on, the appliance is not moved, it will automatically switch off and
the auto off light will blink after the following intervals:
- fter 30 sec., if the iron is left resting on the the soleplate or lying on its side.
- fter 8 mins., if the iron is left resting on its heel.
To switch the iron back on, move the iron gently.
FTER USE
11 • Emptying
Unplug the iron (fig.4), pour away remaining water (fig.20) and set steam control to
.
Open and close the steam control several times (fig.16) to prevent the valve hole into
the steam chamber from scaling or blocking up.
12 • Storing
llow the appliance to cool down before storing the iron standing on its heel (fig.21).
IMPORT NT Do not wind the cord around the hot soleplate. Never store your
iron placed down on the soleplate.
M INTEN NCE ND CLE NING
IMPORT NT Unplug and allow the iron to fully cool down before maintenance
and cleaning.
13 • nti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits. This considerably
prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and does not need to be
replaced.
14 • Self Clean function
(prolongs the life of the iron)
The Self Clean function flushes dirt and scale particles out of the steam chamber.
IMPORT NT Do not use descaling agents, as these damage the lining of the
steam chamber and so may impair the steam function.
Fill the water tank with untreated tap water up to the max mark and heat the iron to
the ••• temperature. Unplug the iron and hold it over a sink horizontally. Hold the Self-
clean button into the Self Clean position (fig.5a-b) and shake it gently: steam will now
begin to build up.
to dampen stubborn creases (fig.18).
5
* depending on model
EN
FR
ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Eco intelligence

Tabla de contenido