Bresser Tendence 70-01 100 Manual Del Usario página 38

• When temperature mode has been selected, press and hold for 2 sec-
onds to toggle the temperature unit between Celsius or Fahrenheit.
H. UP (▲) button
• Press to select the next available mode
• Increase the parameters
• In time with seconds display mode, press and hold for 2 seconds to
activate/ deactivate radio controlled time signal search manually.
I. MEM/ HISTORY button
• When temperature mode has been selected, press to recall the
minimum or maximum temperature and humidity readings of main and
remote units.
• Press and hold for 2 seconds, collected memories will be cleared.
• When pressure mode has been selected, press once to check the
historical pressure data for the past 24 hours.
J. WALL- MOUNT hole
• A recessed opening to mount the unit on a wall
K. BATTERY COMPARTMENT
• Accommodate two (2) CR2032 batteries
L. TABLE STAND
PLACEMENT
• Make sure that the main unit is locating within the operating range of
all remote sensors.
• Ideally the main unit should be placed within line of sight of remote
sensors. Avoid placing the main unit where surfaces emitting and
162mm
Wallmount
38