Bresser Tendence 70-01 100 Manual Del Usario página 48

SETTING THE WEEKDAY (W) AND SINGLE DAY (S) ALARMS
• Press ALARM button once to enter into the alarms setting mode. The
default alarm is a Weekday alarm (W). The abbreviation "OFF" with
a letter "W" next to it will be displayed, if the alarm has not been set
previously
• Press and hold ALARM button for two seconds. The hour digit will fl ash
• Adjust the hour using UP (▲) or DOWN (▼) buttons
• Press ALARM button again. The minute digits will fl ash
• Adjust the minutes using UP (▲) or DOWN (▼) buttons
• Press ALARM button again to confi rm and the weekday alarm time
will be set
• Set Single (S) day alarm if desired in the same manner
SETTING THE ICE WARNING ALARM (PRE-AL)
If Weekday (W) or Single day (S) alarm is MODE, the Ice Warning Alarm
(Pre-AL) can be programmed.
• Press ALARM button once to enter into the Ice Warning Alarm set-
ting mode. The abbreviation OFF with a PRE-AL next to it will be
displayed.
• Press and hold ALARM button for two seconds. The number 30
will fl ash, meaning that if selected, the alarm will sound 30 minutes
earlier than the Weekday or Single alarm.
• Select the desired Ice Warning Alarm interval in 15 minutes incre-
ments between 15 and 90 minutes, using UP (▲) or DOWN (▼)
buttons
• Press ALARM button to confi rm and exit from the alarm setting
mode.
ACTIVATING/ DEACTIVATINSALARMS
• Press ALARM button to enter into the desired alarm mode.
• Press UP (▲) to activate alarm and the corresponding icons W, S or
PRE-AL will be displayed.
• Press DOWN (▼) to deactivate alarm until "OFF" is displayed.
48