Klarstein Botella 166 Uno Manual Del Usuario página 34

EN
34
Your wine cooler can be used as a freestanding or a built in unit. If you are going to
use it as a built in unit, then the dimensions shown in the diagram above will need to be
followed. In particular the depth dimension must be observed.
Installing the handle
• Remove the door gasket on the side you wish to install the handle. You can see two
designated holes for handle installation.
• Install the handle tightly as shown in the diagram above with the two screws, lock
washers and flat washers provided.
• Replace the door gasket
Reversing the door of your wine cooler
This appliance has the capability of the door opening from either the left or right hand
side. Any parts that you remove from the appliance whilst reversing the door, should be
retained for later use.