Troubleshooting - Unold 48935 Instrucciones De Uso

DE

TROUBLESHOOTING

EN
FR
NL
IT
ES
PL
basket, the water level might be too low. If there is sufficient water in the
appliance, carefully push the shovel towards the back, using your fingers,
and then restart the appliance.
Problem
Loud noise from com-
pressor.
„Add Water" indicator
lit.
None of the indicators
is lit when the ice cube
maker is switched on.
30 von 96
1. Important: If ice cube production is interrupted, for
instance by a power failure, disconnection from power
supply or inadvertent pressing of the „ON/OFF" button,
small pieces of ice might form on the ice cube shovel
(fig. 1). Pull the plug from the power socket, push the
shovel towards the back of the appliance and remove
the ice.
2. If the shovel does not transfer the ice cubes into the
Cause
Voltage too low.
Insufficient water in wa-
ter tank.
Air in pump.
The appliance is not
connected to the power
supply.
An appliance compo-
nent is defective.
Remedy
Switch off the appliance
and check whether it is
correctly connected to a
220–240 V~ power so-
cket.
Add water to the "Max."
mark.
Press the "ON/ OFF" but-
ton to start the ice cube
maker.
Check whether the plug
is correctly inserted in
the power socket.
Contact our customer
service department.
Stand 25.1.2021