Replenishing Staples - Kyocera DF-730 Guía De Uso

5. Open the top cover and remove any
jammed paper inside that cover.

Replenishing staples

If an indication that staples have run out
appears on the operation panel of the copier
(or the message display of the printer),
perform the following procedure.
3. Remove the empty staple cartridge from
the staple holder.
8
6. Close the top cover and the reversing
unit cover and reattach the Document
Finisher to the copier (or printer).
1. Open the stapler cover.
4. Hold the staple holder in one hand and
the new staple cartridge in the other, and
set the new cartridge into the staple
holder paying due attention to the
direction of insertion.
* Insert in the direction of the arrow
shown on the staple cartridge.
2. Pull out the stapler holder.
5. Push the staple cartridge all the way into
the staple holder and then peel off the
paper tape that is attached to the
cartridge.