Setup Menu - DeFelsko PosiTector UTG CA Guía Rápida

Reset
Reset (menu reset) restores factory settings and returns the
Gage to a known condition. The following occurs:
- All batches, stored measurements, batch names and screen
captures are erased.
- All calibration adjustments are cleared and returned to the
Gage's factory calibration settings.
- Menu settings are returned to the following:
Memory = OFF
Statistics = OFF
Hi Lo Alarm = OFF
Min Scan = OFF
Reading Tick = ON
Auto Dim = ON
Perform a more thorough Hard Reset as follows:
1. Power down the Gage and wait 5 seconds.
2. Simultaneously press and hold the ( + ) and
buttons until the Reset symbol
This returns the Gage to a known, "out-of-the-box" condition.
It performs the same function as a menu Reset with the addition of:
- Bluetooth Pairing info is cleared.
- Menu settings are returned to the following:
Units = millimeter
Flip Display = Normal
Auto Sync .net = ON
Sound = ON
Date,Time and WiFi settings are not affected by either Reset.
NOTE:
Min Scan
Normally, the PosiTector UTG continuously takes spot
measurements while in contact with a surface. When the probe is
lifted, the last reading will remain on the display. However, it is
sometimes necessary to examine a larger region to locate the
thinnest point. When Min Scan is selected, the PosiTector UTG
will take continuous readings and record min/max thicknesses

Setup Menu

A Scan = OFF
B Scan = OFF
Cal Lock = OFF
SE Mode = OFF
USB Stream = OFF
Language = English
Battery Type = Alkaline
Backlight = Normal
Bluetooth Smart = OFF
USB Drive = ON
9
Display = None
SmartCouple = OFF
Bluetooth & Stream = OFF
WiFi & Access Point = OFF
USB Keyboard = OFF
appears.
center