Ariston Net Installation; Important - Ariston 3318884 Instrucciones De Instalacion Y Uso

GB

5. ARISTON NET INSTALLATION

This chapter describes the installation procedure of Ariston Net. We recom-
mend to start up the procedure making fi rst the gateway connection with the
thermoregulation accessory and with the heating product. After that, it will be
possible to connect the gateway to the power supply and to fasten it to the wall
through the wall plate.

Important:

The installation of Ariston Sensys is possible only with Ariston products run-
ning the Bus BridgeNet protocol. If there is an existing thermostat connected
to the heating system replace as follows: Remove the existing room thermo-
stat following the procedure described it its installation manual, the 2 core ca-
ble has to be unplugged from the TA1 connector on the boiler (Paragraph 5.1).
CAUTION!
The installation must be performed by qualifi ed personnel. Before its assembly,
switch off the power supply of the boiler. The Bus BridgeNet cable is polarized:
to avoid any communication issue respect the polarity between all the products
in the heating system.
5.1 Possible installation architectures
With the intent to give several examples to lead the installation of Ariston Net, in
the following paragraph are reported some major system diagrams that could be
realized through Ariston net and other accessories already in the Ariston products
range. With each example, is also specifi ed which services can be activated.
The term "Remote Diagnostics" (RD) refers to the utility dedicated to Service Cen-
ters, through which all the assistance features of Ariston Net are enabled.
"Remote Control" (RC) refers instead to the service oriented to the end user, throu-
gh which he can use the Ariston Net smartphone app or web portale to monitor and
set its Ariston products.
For further info and details on the installation diagrams shown below, please con-
tact the Ariston Technical Center of your Country.
36 /