First Start And Internet Connection - Ariston 3318884 Instrucciones De Instalacion Y Uso

GB

6. FIRST START AND INTERNET CONNECTION

In this chapter it is described how to connect the Ariston Net system to internet,
through two diff erent procedures depending on whether a ADSL or GPRS gate-
way version is used.
6.1 Internet connection through ADLS router
Ariston Net can communicate with
an ADSL router using a LAN cable or
Wi-Fi connection.
In the latter case, please skip to step
2 of the following procedure.
1. With Ariston Net switched OFF
and not connected to the power
line, open the front panel, con-
nect the LAN cable to its connec-
tor and close the panel.
2. Power supply the gateway and
press the ON/OFF button. For few
minutes the gateway performs its
startup procedure, during all LEDs
will fl ash a blue sequence. At its
conclusion, the WEB led remains
fi xed red, while the BUS remains
fi xed green.
3. Press and hold the start-up but-
ton for at least 5 seconds, until
the WEB led start to fl ash a green
light. At this point the gateway has
created a new Wi-Fi access point
that will be kept active for 10 mi-
nutes. After this time elapsed, it
will be possible – if necessary – to
repeat the procedure.
4. Open the network settings of
your personal internet device
(smartphone, pc, tablet..) and
search for new Wi-Fi networks
available. Select the Remote GW
Thermo network.
44 /
NOTE:
Ariston Net is compatible with the
following Wi-Fi security settings:
- WEP
- WPA/WPA2 Personal
220V
BUS BUS
TA1
B T B T
A