Preface; Safety Instructions And Warnings; Use According To The Intended Purpose; Mounting In A Control Panel - Kübler CODIX 560 Manual Del Usuario

1

Preface

Please read this instruction manual
entirely and carefully before installation
and start-up. Please observe all warnings
and advice, both for your own safety and
for general plant safety. If the device is
not used in accordance with this
instruction manual, then the intended
protection can be impaired.
2 Safety instructions and
Warnings
Please use the device only if its technical
condition is perfect. It should be used
only for its intended purpose. Please
bear in mind safety aspects and potential
dangers and adhere to the operating
instructions at all times.
Defective or damaged devices should be
disconnected from the mains immediately
and taken out of operation.
The device shall not be opened. Use the
repair service of the manufacturer.
Only connect the device to the electricity
networks provided to that purpose.
The safety of the system in which the
device is integrated is the responsibility
of the installer.
Disconnect all electricity networks prior to
any installation or maintenance work.
Use exclusively cables approved in your
country and designed for your
temperature and power ranges.
Installation and service work shall be
carried out exclusively by qualified
personnel.
The device must compulsorily be
protected with approved external fuses.
The value of these fuses can be found in
the technical information.
This symbol is used on the device to
remind of the existence of dangers, which
are referred to in this manual.
2.1 Use according to the intended
purpose
The preset counter 560 detects and measures pulses,
times and frequencies up to max. 60 kHz and offers a
wide variety of different operating modes. At the same
time, the preset counter processes programmed
Page 4
presets. Use for any purpose over and beyond this will
be deemed as not in accordance with its intended
purpose and thus not complying with the
requirements.
The application area for this device lies in industrial
processes and controls, in the fields of manufacturing
lines for the metal, wood, plastics, paper, glass, textile
and other like industries. Over-voltages at the
terminals of the device must be kept within the limits
of Over-voltage Category II.
The device must only be operated when mounted in a
panel in the correct way and in accordance with the
section "Technical Data".
The device is not suitable for use in hazardous areas
and for areas excluded in EN 61010 Part 1. If the
device is used to monitor machines or processes in
which, in the event of a failure of the device or an
error made by the operator, there might be the risk of
damaging the machine or causing an accident to the
operators, it is your responsibility to take the
appropriate safety measures.
The device has been designed for indoor operation. It
may nevertheless be used outdoors, provided the
technical data is adhered to. In this case, take care to
provide suitable UV protection.
2.2

Mounting in a control panel

Mount the device away from heat
sources and avoid direct contact with
corrosive liquids, hot steam or similar.
CAUTION
Provide a free space of 10mm all
around the device for its ventilation.
The device should be mounted so that
the terminals are out of the reach of the
operator and cannot be touched by him.
When mounting the device, consider
the fact that only the front side is
classified as accessible for the
operator.
Mounting instructions
1. Remove the mounting clip from the device.
2. Insert the device from the front into the panel cut-
out, ensuring the front-panel gasket is correctly
seated.
3. Slide the fixing clip from the rear onto the
housing, until the spring clamps are under
tension and the upper and lower latching lugs
have snapped into place.
Note: In case of proper installation, IP65 can be
reached on the front side.
www.kuebler.com