Selecting The Main Menus; Entering A Sub-Menu; Selecting The Parameters; Changing Parameter Values - Kübler CODIX 560 Manual Del Usuario

Enter the main menu by pressing
the ENTER key
The first menu item in the main
menu appears in the display
When ending the programming via PROG.
NO the counter contents are not reset.
7.2

Selecting the main menus

The main menus are selected
using the UP and DOWN keys
Indicated by LED1
7.3

Entering a sub-menu

Press the ENTER key.
The first parameter is displayed
with the current setting flashing.
Indicated by LED1 and
LED2
7.4

Selecting the parameters

The parameters are selected
using either the RIGHT key or
the LEFT key.
7.5

Changing parameter values

Press the ENTER key.
Change the parameter value
using the UP or DOWN keys.
Press the ENTER key.
The new setting is again
displayed flashing.
7.6

Setting count values

Press the ENTER key.
Select the decade using the
RIGHT key or the LEFT key.
www.kuebler.com
the corresponding
decade flashes
Change the count value using
the UP key or the DOWN key.
Press the ENTER key.
The new setting is again
displayed flashing.
7.7

Ending the programming

Select the menu item
Pressing the ENTER key
acknowledges this prompt and
allows the programming to be
repeated. The previously-
programmed values are
preserved. These can now be
checked or changed once again.
Pressing the UP key or the
DOWN key selects the
termination oft he programming.
The security prompt YES
appears in the display
Pressing the ENTER key
acknowledges this prompt and
terminates the programming; the
modified settings are saved in
the EEPROM.
The text SAVE is shown in the
display for 2 sec.
When ending the programme via
END.PRG. YES the counter contents are
reset.
No count pulses, frequencies or times are
detected or measured whilst programming
is taking place.
7.8

Programming menu

Factory settings are highlighted in grey

7.8.1 Select language

Submenu: Select language
Help Text
Help Text ON
Help Text OFF
Page 7