MWE820, 860, 890
10
Using the parking aid
The rear sensors (MWE820, 860) are activated automatically by engaging
the reverse gear with the ignition on or the engine running. The speaker will
emit a double beep.
The front sensors (MWE890) are automatically activated as soon as the ig-
nition is switched on and the speed of the vehicle lies between 0 and around
15 km/h.
As an option, instead of being connected to the speed signal, the control
electronics of the front sensors can be connected to the reversing light or an
external switch.
NOTE
I
Before using either of these functions, hold down the button on the
control electronics for 2 seconds (see "Restoring the factory set-
tings" on page 23).
The sensors are active in the following cases:
For around 30 seconds after the motor is started
When the reverse gear is engaged and the control electronics are con-
nected to the reversing light
For around 30 seconds after the reverse gear is disengaged
The sensors can be activated with an external button (accessory) for a du-
ration of around 30 seconds.
As soon as there is an obstacle within the detection range, a repeated signal
tone is emitted.
As you approach, the tone sequence and the flashing frequency change, de-
pending on the zone in which the obstacle is, thus indicating the distance
(fig. d).
MWE860 (optional MWE890): The nearer the obstacle gets, the more LEDs
light up on the display.
EN
Using the parking aid
25