Using The Device; Handling Electrical Cables - Dometic CoolAir RTX1000 Instrucciones De Instalación

CoolAir RTX1000, RTX2000
2.1

Using the device

z Only use the parking cooler for the purpose specified by the manufac-
turer and do not make any alterations or structural changes to the
device.
z Do not use the parking cooler if it is visibly damaged.
z The parking cooler must be installed safely so that it cannot tip over or
fall down.
z Installation, maintenance and repair work may only be carried out by
qualified personnel from a specialist company who are familiar with
the risks involved and the relevant regulations.
z Do not use the parking cooler near flammable fluids and gases.
z Do not operate the parking cooler if the ambient temperature is below
0 °C.
z Do not undo the upper cover of the parking cooler in the event of a
fire. Use approved extinguishing agents instead. Do not use water to
extinguish fires.
z Please inquire from your vehicle manufacturer whether the height
entered in your vehicle documentation needs to be altered due to the
installation of the parking cooler (height 175 mm).
z Disconnect all power supply lines when working on the parking cooler
(cleaning, maintenance, etc).
2.2

Handling electrical cables

z Use cable ducts to lay cables through walls with sharp edges.
z Do not lay loose or bent cables next to electrically conductive
materials (metal).
z Do not pull on the cables.
z Attach and lay the cables in such a manner that they cannot be tripped
over or damaged.
z The electrical power supply may only be connected by a specialist
workshop.
z The connection to the vehicle's electrical system should be protected
by a 40 A fuse for the power supply and a 2 A fuse for the voltage
monitor.
z Never lay power supply lines (battery leads) in the vicinity of signal or
control cables.
EN
Safety instructions
5