Fitting The Parking Aid; Connecting The Parking Aid - Dometic WAECO MagicWatch MWE820 Instrucciones De Montaje Y De Uso

Fitting the parking aid

5 Fitting the parking aid
See fig. 7 to fig. a
Supplementary to fig. 8
NOTICE! Risk of paint damage!
A
 The ambient temperature may not fall below 18 °C when punch-
ing or drilling.
 We recommend using a punching tool.
 Make sure that you do not tilt the punching tool when operating.
➤ Deburr the drill holes.
➤ For a more accurate fit, slant the drill downwards slightly on the inside of
the bumper when drilling the hole. The sensor housing can now be easily
inserted at a downward angle.
Supplementary to fig. 9
NOTICE! Risk of malfunction
A
Note that the sensors must be aligned in a particular direction. The
top of the sensor is marked with an ▲.
6

Connecting the parking aid

NOTE
I
 MWE820, 860: On some vehicles, the reversing light only
works when the ignition is switched on. In this case, you must
switch on the ignition in order to identify the positive and earth
wires.
 MWE890: If the speed signal has been connected to the control
electronics, the sensors are automatically deactivated at a
speed over approx. 15 km/h.
The sensors are reactivated as soon as the speed falls below
approx. 15 km/h.
20
MWE820, 860, 890
EN