Safety And Health - Sagola PACK 6000X Manual De Instrucciones, Lista De Repuestos

To carry out the maintenance, repair or cleaning,
previously disconnect the equipment from the
power and pneumatic grid, after having properly
completed the DEPRESSURISATION process.
The premises must be equipped with adequate
ventilation and in accordance with the regulations
and provisions in force in this respect. Around the
equipment there must only be the amount of
product and solvent required for the work being
carried out. After the job has been completed, one
must return the solvents and products to be
applied, to their specific storage location. Keep the
work area clean and free of potentially hazardous
waste (solvents, rags, etc...)
During the work and in the work area, there should
be no source of ignition (open fire, lit cigarettes,
etc.), as during it highly flammable gases may be
generated. Also one must use type approved
workplace protection (respiratory, auditory, etc.) in
accordance with the Standard set in this regard.
If the equipment is used improperly or its compo-
nents are altered, material damage may appear
and serious physical sequels may occur itself, to
outsiders and/or animals and may even be mortal.
SAGOLA, S.A. shall not be held liable for the
improper use of the equipment.
Always wear type approved breathing equipment
that complies with current standards and regula-
tions to protect yourself against fumes emitted
during the application.
Do not never exceed the maximum working
pressure. The equipment units are preset by the
manufacturer in accordance with the design
features described in their technical data specifi-
cations.
It as a preventive general measure it is recom-
mended to use protective eyewear, in accordance
with the specific regulations and environmental
characteristics of the workplace and the current
regulations.
Use gloves when handling the product (see
manufacturer's recommendations) and when
cleaning the spray gun.

13. SAFETY AND HEALTH

- 25 -
If during the use of the equipment the environmen-
tal noise level exceeds 90 dB it is recommended
the use type approved acoustic protectors. The
spray gun itself is not prone to any mechanical risk
of perforations, impacts or pinching, except for
those derived from improper installation or
incorrect handling.
USE SAGOLA ANTI-STATIC HOSES TO ELIMI-
NATE THE POSSIBILITY
SPARKS THAT COULD CREATE A FIRE OR
EXPLOSION HAZARD.
The handling of the equipment requires adequate
care, in order to prevent the occurrence to it of
damage that could lead to hazardous situations for
the user or people close by, due to leaks, breaka-
ges, etc.
The use of solvents and/or detergents containing
halogenated hydrocarbons
methyl chloride, etc.), can cause chemical
reactions within the equipment, as well as with its
galvanised components
mixed with small amounts of water produces
hydrochloric acid).
As a result, such components can oxidise and in
extreme cases, the arising chemical reaction may
be explosively. We recommend the use of
products that do not contain the aforementioned
components. Under no circumstances should one
use any acids, soda (alkalis or strippers, etc.) for
cleaning.
In general, any handling of the equipment must be
done with care so as to not damage it. The
coupling joints must be well tightened and in good
working condition.
The safety rules must be understood and applied.
Failure to comply with the indications of this
manual may lead to incidents that may affect the
physical integrity of the user or other people or
animals.
Respect and comply with the indications relating
to the preservation of the environment.
OF ELECTRIC
(trichloroethane,
(the trichloroethane