Sony SRS-X7 Manual De Uso página 21

Ocultar thumbs Ver también para SRS-X7:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How to check Wi-Fi signal strength
(reception sensitivity)
ˎWhile the unit is connected to Wi-Fi (the
LINK indicator lights up in green), tap and
hold the NETWORK button until you hear a
beep.
3
2
1
0
Signal
Number of flashing
strength
indicators
Function buttons on the top panel of the unit
start to flash. The number of flashing indicators
shows the strength of the signal. Flashing stops
when any button is tapped.
To receive a stronger signal, try the following:
ˋ Change the direction of the wireless LAN
ˎ
antenna.
ˋ Turn off other wireless devices.
ˎ
How to use the BLUETOOTH/Network
standby function
If the BLUETOOTH/Network standby function is
on, the unit turns on automatically by operating
a BLUETOOTH device or network device, even if
the unit is turned off. The unit will start up more
quickly than usual.
ˎCheck that the AC adaptor is connected,
then turn on the unit.
ˎPress and hold the / (on/standby) button
until it lights up in orange.
The unit turns off and enters the BLUETOOTH/
Network standby mode.
If you operate a BLUETOOTH device or network
device, the unit turns on automatically and
connection starts.
How to initialize the unit
Initialize the unit if these measures do not
resolve the problem or if the settings fail.
ˎMake sure the unit is turned on. Tap (press)
and hold both the VOL (volume) – button
and / (on/standby) button at the same
time for more than 5 seconds.
The unit will turn off. Settings will return to their
factory defaults, and all BLUETOOTH pairing
information and network settings will be reset.
21
US

Publicidad

Tabla de contenido
loading

Tabla de contenido