Grouw 18038 Manual De Instrucciones página 26

Turn the garden shredder so that it is
standing on its wheels (6) and feet (7).
Lift the button up and push the collector
(4) into the grooves on the underside of the
garden shredder.
Tighten the feed hopper (1) using the � nger
screw (10).
10
The � nger screw activates an internal contact
so that the garden shredder cannot start if
the � nger screw is not tightened fully.
Do not use the garden shredder unless
the feed hopper has been positioned and
tightened correctly!
26
button
Use
Make sure that the collector (4) is � tted
corrected so that it can collect the shredded
material. Alternatively, you can place the
garden shredder on a tarpaulin to collect the
shredded material.
Check that the feed hopper (1) and feed pipe
are empty.
Connect the garden shredder plug to a
suitable extension lead for outdoor use.
Switch the garden shredder on at the on/off
switch (8) and allow the blades to reach full
speed.
Note! If the garden shredder cannot be
switched on at the on/off switch, press the
reset button (9) and then press the on/off
switch again.
Push the garden waste down into the feed
hopper and allow the blades to pull it down
into the feed pipe as it is gradually shredded.
The shredded waste will come out of the
discharge chute.