Supplied Accessories; Attaching The Stand; Symbols Used In This Manual - Emerson LC195EM87 Manual Del Usuario

I
NTRODUCTION
The serial number of this product may be found on the back of the unit. No others have the same serial number as yours. You
should record the number and other vital information here and retain this book as a permanent record of your purchase to aid
identification in case of theft.
date of purchase
dealer purchase from
Note about recycling:
This product's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your
local recycling regulations.
Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning
chemical wastes.

Supplied Accessories

owner's manual
(1EMN22282)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
• Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters).
Contact your local electronics store for these items.

Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Turn the main unit over and place
it onto a table which has a soft
cloth draped over it. Make sure
not to damage the screen.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.

Symbols Used in this Manual

The following is the description for the symbols used in this manual.
Description refers to:
: Digital TV operation
DTV
: Analog TV operation
TV
• If neither symbol appears under the function heading, operation is applicable to both.
4
EN
dealer phone No.
model No.
remote control
(NF604UD)
2
Insert the stand all the way to the
main unit slowly.
serial No.
dealer address
batteries
(AA x 2)
3
Drive Phillips pan screws in the 2
threaded holes with a screwdriver
tightly.
Phillips pan screw for
attaching the stand x 2
(FPH34140)