Health O Meter PROPLUS 1600KL Instrucciones De Uso página 5

ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the 1600KL Scale:
It is recommended that the assembly be done by two people.
1) Remove the scale assembly from the carton by first removing the inserts, then tuck the bag down
around the end of the box, and finally tilt the carton up on its end and roll the scale out.
2) Remove the bag from the scale, using caution to store the bag in the carton or to discard it, for safety.
3) Thread the 4 feet into the underside of the base. Each foot should be completely hand tightened and
then backed out 1-½ full turns. This allows for proper load cell operation for accuracy of the scale.
4) Open the scale to operational position (see scale opening instructions on page 8). WARNING: Do not
drop the scale on its feet. This could result in load cell damage.
5) Rotate the display support so that it is perpendicular to the handrail.
6) Position the display assembly close to the display support on the handrail. Connect the load cell cable
connector to the load cell port on the rear of the display assembly and insert and secure the cable into
the center channel in the display. NOTE: Do not attach the Power Cord at this point—wait until step 10,
below.
7) Slide the display assembly onto the display support by inserting the two metal supports into the two slots
in the rear display assembly. Tuck the excess load cell cable into the handrail tube. NOTE: The load
cell cable should now be secured in the channel between the display assembly and the display support
(see Figure 2, below).
8) Insert the 4 Phillips pan head M4 screws into the metal display support, and tighten.
9) Attach the Adapter Holder to the inside of the handrail using two (2) #8 x ½ sheet metal screws; tighten.
10) Connect the power adapter to the power port in the display, then insert and secure the cable into the
exposed portion of the second channel from the left in the back of the display (see Figure 2). Hold the
cord in place through the retaining slot on the rear cover and align the large rear cover tabs with the
slots on the rear of the display assembly. Apply light pressure to snap the cover into place and secure it
with 2 Phillips pan head M4 screws. Do not plug the scale into a power source until the scale is
fully assembled.
11) Rotate the display to align it with the center handrail then attach the front and small rear display support
covers, applying light pressure to snap these covers into place.
12) Secure the power cord to the inside of the center handrail, using the 4 plastic cable clips, arranged to
hold the cord out of the way. The adhesive backing on the clips will peel off then the clips can be
fastened to the scale by applying light pressure.
13) Make any necessary adjustments to level the scale by turning the feet in or out as needed.
14) The scale is now assembled. Plug the scale adapter into a power source and / or insert batteries.
Figure 2
- 4 -