Initial Operation; Change Collet Chuck - Parkside POFA 12 A1 Traducción Del Manual De Instrucciones Original

Fresadora de superfi cie recargable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GB
MT
a) Injuries caused by moving parts;
b) Ear damage if working without ear pro-
tection;
c) Lung damage, if suitable respiratory
protection is not worn;
d) Eye injuries if no suitable eye protection
is worn.
e) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.
Observe the safety informa-
tion and notes on charging
and proper use as shown
in the instruction manual
for your battery and char-
ger from the Parkside
X 12 V Team series.
A detailed description of the
charging process and further
information can be found in
the separate operating inst-
ructions.
50

Initial operation

Remove the battery from the power
tool before carrying out any work.
Risk of injury!
Before you turn on the machine, you must
-
change collet chuck if necessary
-
connect the dust suction,
-
insert the desired cutter,
-
adjust the cutting depth,
-
mount the parallel stop if necessary,
-
clamp in the workpiece.
-
insert the battery

Change collet chuck

The collet chucks suitable for the device
can be used with a shank diameter of
6 mm or 8 mm.
Only use the cutter with a
shank diameter suitable for
the installed collet chuck.
Use only cutters that are
suitable for the speed of the
power tool.
All cutters of the 6-part cutter set included
in the delivery are provided with an 8-mm
cutter shaft.
Change the collet chuck for cutters with a
6-mm cutter shaft.
1. Press the spindle locking button (10)
on the side of the device and keep it
pressed down.
2. Screw off the cap nut (11) using the
combination wrench (
19).

Publicidad

Tabla de contenido
loading

Tabla de contenido