♦
If necessary, use the reducer
onto the dust extraction adapter
♦
Switch the dust extractor on when making drill
holes.
♦
To detach the extractor, follow the above steps
in reverse order.
Operation
Select operating mode
Function selector switch
♦
Move the function selector switch
required symbol engages:
Function
Drilling
Impact drilling
Select direction of rotation
WARNING!
►
The rotation direction switch
used/adjusted if the device is at a standstill.
♦
Select the direction of rotation by pressing the
rotation direction switch
right.
2-speed gearbox
CAUTION!
►
Operate the speed selector
the appliance is at a standstill. Otherwise,
the appliance can be damaged. If it is not
possible to move the selector, briefly press
the ON/OFF switch
►
Press the speed selector
in the lower half of the dial! Turn
the speed selector
required gear engages at the
marking.
PSBM 1100 B1
by pushing it
.
so that the
Symbol
may only be
towards the left or
only when
and then try again.
only
so that the
In first gear
(speed selector switch
This setting is suitable for light drilling, pre-drilling,
work using a large-diameter drill, and the use of
accessories.
In second gear
(speed selector switch
This setting is suitable for carrying out drilling work
with a small-diameter drill.
Preselecting the rotation speed
You can use the rotational speed preselector
adjusting wheel
speed. The speed you select depends on the mate-
rial to be processed. Work out the correct settings
by carrying out a test.
NOTE
►
The appliance only reaches the set rotational
speed during continuous operation.
Switching on and off
Switching the appliance on
♦
Press the ON/OFF switch
Switching the device off
♦
Release the ON/OFF switch
Switching to continuous operation
♦
Press the ON/OFF switch
pressed position with the ON/OFF switch lock
button
.
Switching off continuous operation
♦
Press the ON/OFF switch
again.
in position 1)
in position 2)
to preselect the rotational
.
.
. Lock it in the
and release it
GB │ IE
│
7
■