Before First Use - Hamilton Beach 40715 Manual Del Usuario

Before First Use

1
Make sure all three buttons are in the
OFF position (not pushed in) and that the
steam control dial is turned fully clock-
wise to NO STEAM .
5
Turn the steam control dial counter-
clockwise to STEAM . Press pump
button to pump hot water out of frothing
wand for cleaning purposes.
4
(Priming the Pump)
2
Fill the removable water reservoir to the
MAX fill line with cold water and replace
securely on the back of unit.
6
Fill the container about halfway full.
NOTE: The green light next to tempera-
ture selection button will turn off once
pump button is pushed.
Wash all removable parts in warm, soapy water. No parts may be washed in a dishwasher.
The water pump must be "primed" before first use to work properly.
Operating without water in the reservoir can permanently damage the appliance.
3
Plug in the unit and press ON/OFF button
to turn unit on.
7
Press pump button again to turn frothing
nozzle off; then turn steam control dial
clockwise to NO STEAM .
4
When unit is ready, the light next to the
temperature control button will glow
green. Place an empty container under
frothing nozzle so that nozzle is completely
inside container.
8
Place a container under brew head–it should
be wide enough to catch water from both
spouts. Press pump button and dispense any
remaining water from reservoir.