Calculating And Printing Out Bmi Automatically; Automatic Switching Of Weighing Range; Switching Off The Scale - Seca 635 Manual De Instrucciones Y Garantía

Calculating and printing
out BMI automatically
Automatic switching of
weighing range

Switching off the scale

80 •
If you use this scale together with a wireless printer and
a length measuring rod from the
system, you can have BMI calculated and printed out
automatically.
NOTE
The prerequisite for this function is that the
devices are registered together in one wireless
group (see "The seca 360° wireless network"
on page 86).
1. Perform the height measurement.
2. Briefly press the Enter key (send/print) of the
length measuring rod.
The measured value is sent to the wireless printer
but not printed.
3. Perform the weighing operation.
4. Press and hold the Enter key (send/print) of the
scale.
The measured value is sent to the wireless printer.
BMI is calculated.
Height, weight and BMI are printed out.
The scale has two weighing ranges. In weighing range
1 ( ), capacity is reduced, but the increments in the
weight display are finer. In weighing range 2 (
can use the maximum capacity of the scale.
After the scale is switched on, weighing range 1 is
active. If a particular weight is exceeded, the scale
automatically switches to weighing range 2.
To switch back to weighing range 1, proceed as
follows.
Completely remove the load from the scale.
Weighing range 1 is active again.
Press the Start key.
NOTE
In battery mode, the scales will switch off auto-
matically after 5 minutes if no load is placed on
them.
seca 360° wireless
), you