Troubleshooting Guide; Electrical Shock Hazard - KitchenAid KSB40 Serie El Manual Del Propietario

TROUBLESHOOTING GUIDE

Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
Problem
If Blender fails to start:
If Blender stops after 3 minutes:
If Blender stops while blending:
If ingredients are stuck or not
blending:
If Blender stops while blending
with Personal Jar or Small Batch
Jar:
If Blender stops while blending
and the white LED ring flashes
rapidly:
If the white LED ring is off
If the problem is not due to one of the above items, see the "Warranty and Service" section.
Do not return the Blender to the retailer. Retailers do not provide service.
10
W11408297B.indb 10
WARNING

Electrical Shock Hazard

Check if the Blender is securely plugged into a grounded
3 prong outlet.
If you have a circuit breaker box, make sure the circuit is
closed.
It's a part of the Blender operation to ensure lasting
durability. Turn the Control Dial to (O) and repeat the
process until desired consistency.
When overloaded or jammed, it will automatically shut off
to prevent motor damage. Unplug the Blender. Remove
the Jar and use a spatula to rearrange ingredients.
Or, divide contents into smaller batches. For certain
recipes, adding liquid in the Jar may also reduce the load.
Unplug the Blender. Remove the Jar and use a spatula to
rearrange ingredients in the Jar.
Unplug the Blender. Remove the Personal Jar or Small
Batch Jar with the Blade Assembly from the base. Shake it
a little bit. Place it back on the base, plug in the Blender
and turn it back on to continue regular use.
An error is detected in the Blender. Contact an authorized
service center for assistance. Please see the "KitchenAid
Warranty and Service" sections.
10 minutes of no activity will make the Blender go into
Sleep mode. To wake up the Blender, press (
Solution
10/18/2019 6:43:37 PM
®
) button.