Intended Use; Environmental Protection - Worx Slide Driver WX254 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE

The power tool is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
ACTION
Before operation
Charging the Battery
NOTE:
1. Maximize Battery Performance
Prior to initial use, the battery must be charged
5 hours to fully utilize the battery capacity.
2. When the battery is full charged, the
light turns green.
Assembly and adjustment
Inserting and Removing the Bit Cartridge
Selecting the Proper Bit
WARNING: Do not stare directly
into the tool holder. When
changing the tool insert, it can be
thrown out toward the front.
NOTE: Slide the Cover fully open, past
the red line on the tool. The Bit Cartridge
will advance automatically.(The Bit
Cartridge may be manually rotated to
the left to select the Bit as well.)
Forward/reverse/lock
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it is stopped!
Operation
Operating the On/Off Switch
WARNING: Do not operate for
long periods at low speed
FIGURE
because excess heat will be produced
internally.
LED Light Indicator
See Fig. A
MAINTENANCE
Your power tool requires no additional lubrication or
maintenance. There is no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
See Fig B1,B2
ventilation slots clean. Keep all working controls free of
dust. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your power tool.

ENVIRONMENTAL PROTECTION

See Fig C1,C2
Waste electrical products must not be disposed of
with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
See Fig.
E1,E2,E3
See Fig. F
See Fig. F
13