Charging The Batteries - Silvercrest SHAZ 22.2 B2 Instrucciones De Uso

♦ Select a suitable mounting location for the wall bracket f:
You must be able to easily place the handheld vacuum cleaner into the
bracket or remove it, and the mains socket must be easily accessible .
Ensure that the appliance is not exposed to direct sunlight or other heat
sources .
♦ Mark two drill holes on the wall at a distance of approx . 154 mm from each
other . Ensure that there is a mains power socket in the immediate vicinity .
♦ Use a 5 mm drill bit to drill the required holes and insert the wall plugs .
♦ Screw in the screws so that the heads protrude a few millimetres . Hang
the wall bracket f on the two screws using the slotted holes on the rear .
Ensure that the screws slide into the two slots . The wall bracket f should lie
flush against the wall . You can adjust the distance to the wall and compen-
sate for any unevenness in the wall by screwing in or unscrewing the screws .
♦ You can place the nozzles on the accessories holder d on the side .
♦ Now plug the barrel plug h of the mains adapter into the top of the wall
bracket f and the mains adapter g into a wall socket .

Charging the batteries

■ The appliance runs on rechargeable lithium-ion batteries .
■ The indicator lamp 3 shows the charge level of the batteries (25%, 50%,
75%, 100%) . If the batteries are empty, all of the bars start to flash for a
few seconds before the appliance switches itself off .
■ There are two ways of charging the batteries .
–
Plug the barrel plug h of the mains adapter directly into the connection
1 on the appliance and the mains adapter g into a wall socket .
–
Plug the barrel plug h of the mains adapter directly into the connection
on the wall bracket o and the mains adapter g into a wall socket .
Hang the appliance into the wall bracket f so that the plastic tab on
the wall bracket f slides into the recess between the hand element 4
and the dirt container t . The contacts should now be connected to
each other .
NOTE
► The appliance cannot be operated during charging .
■ Depending on the charge level, the current bar on the indicator lamp 3
will flash during charging . The charging process is completed when all four
bars light up .
SHAZ 22.2 B2 GB │ MT │ 57 ■