How To Operate Your Ceiling Fan - Fanimation The Multimax FP8008CH1 Manual Del Usaurio

How to Operate Your Ceiling Fan

1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 1).
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
2.
LEARN MODE PROCESS: (
1. Control and receiver have been factory programmed.
If replacing the transmitter or receiver, the learn mode
process will need to be used.
2. After installing the unit and restoring power to your fan,
open the battery cover (with batteries, DC1.5V/AAA
4pcs, installed) and press and hold the "LEARNING
BUTTON" 1~3seconds with a ball-point pen or similar
object. FAN will turn off and then turn to medium speed
and light on, which indicates that the learning process
has completed.
IMPORTANT: You must press the "LEARNING
BUTTON" within 60 seconds of restoring power to the
fan. Remote does not need to be re-learned when
replacing the battery.
3. If light kit has CFL bulbs, please slide the "light dimmer
function select switch" to on/off position. If installed
incandescent light bulbs onto ceiling fan, please slide
the "light dimmer function select switch" to dimmer
position.
4. Please note, the remote can learn multiple receivers.
3.
REMOTE FUNCTIONS: (
: Touch and release immediately to turn fan on or off
: Touch and release immediately to turn change fan
speeds low/medium/high
: Touch to select run time desired—from 1 to 12 hours.
Fan will turn off after selected time duration.
: Touch and release immediately to turn light on or off
(CFL) Touch and release this key to brighten light to
the desired level (Incandescent)
: If light is on, touch and release immediately and light
will turn off after 3 minutes
: If light is off, touch and release immediately and light
will turn on. After 3 minutes, light will turn off.
4. If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Slide the coupling cover up to expose the reverse
switch. Then slide the reverse switch on top of
motor assembly to the opposite position and turn
fan on again (Figure 4).
Reverse Switch Information
Season Rotation Direction
Summer Counter-Clockwise
Winter Clockwise
Figure 2)
Figure 3)
Switch Position
Left
Right
ON/OFF
DIMMER
LEARNING
BUTTON
LIGHT DIMMER FUNCTION
SELECT SWITCH
Upper
Housing
13
MAIN FUSE BOX
Figure 1
Figure 2
Install Remote Control
Wall Mount Holder
with two screws.
Figure 3
Reverse
Switch
Figure 4