Hoover Elite Rewind UH40070 Manual Del Propietário página 6

2-11
Removing hose
When using cleaning tools, cleaner
handle should be in the upright
position. Also, turn cleaner OFF
before disconnecting and con-
necting hose to hose tube (A).
To use hose, lift hose end (B) as shown.
When you are finished cleaning with the
tools, reposition hose end onto tube.
2-14
Combination tool
Slide brush to remove.
To replace brushes, align brush with
grooves on tool. Slide brush into place.
6
2-12
B
Select proper tool
A
C. Combination tool use with brush
attached for carved furniture, table tops,
books, lamps, lighting fixtures, venetian
blinds, baseboards, shutters, and reg-
isters.
Remove brush to clean upholstered fur-
niture, draperies, mattresses, clothing,
and carpeted stairs.
D. Crevice wand may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
It can also be used for extra reach with
the dusting brush.
3. Maintenance
Familiarize yourself with these home
maintenance tasks as proper use and
care of your cleaner will ensure contin-
ued cleaning effectiveness.
3-1
Air flow indicator
The indicator (A) will show yellow when
the dirt cup is full or there is a blockage
or clog in the system. Turn cleaner
OFF and unplug. Check the dirt cup
and empty if necessary. Turn cleaner
back on. If the indicator still shows
yellow, follow the instructions under
"Clearing blockages".
2-13
C
D
Attach wand and tools
Attach tool to the hose (F) by pushing it
firmly onto hose.
Twist wand or tool slightly to tighten or
loosen the connection.
Dirt cup
When to empty
A
It is recommended that the dirt cup be
emptied before the dirt reaches the fill
line (A), or after every use if preferred.
CAUTION: Very fine materials,
such as face powder or corn-
starch, may seal the filter and
cause loss of suction. When using
the cleaner for this type of dust,
empty the cup and clean the
filters often.
F
3-2
Continued >>
A