Spark Arrester Screen; Spark Plug; Carburetor Adjustment; Storing A Chain Saw - MTD Yard Machines MTD1435a Manual Del Operador

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
MAINTENANCE AND REPAIR INSTRUCTIONS

SPARK ARRESTER SCREEN

NOTE: A clogged spark arrester screen will dramatically
reduce engine performance.
1. Remove the 2 nuts (A) and pull muffler out. (Fig. 37).
2. Remove the 1 screw (B) that holds the spark
arrester cover (C) . (Fig. 38)
3. Discard the used spark arrester screen (D) and
replace it with a new one.
4. Reasemble the muffler components and install the
muffler to the cylinder. Tighten securely.
A
B
Fig. 37
C
A
B
Fig. 38

SPARK PLUG

NOTE: For efficient operation of saw engine, spark plug
must be kept clean and properly gapped.
1. Push STOP switch down to stop position.
2. Remove air cleaner cover.
3. Disconnect the wire connector (A) from the spark
plug (B) by pulling and twisting at the same time
(Fig. 39).
4. Remove spark plug with spark plug socket wrench.
DO NOT USE ANY OTHER TOOL.
WARNING:
trodes. Grit in the engine could damage the
cylinder.
5. Check electrode gaps with wire feeler gauge and set
gaps to .025" (.635mm) if necessary.
6. Reinstall a new spark plug.
NOTE: A resistor spark plug must be used for replace-
ment (Part no. 9295-310801, Champion RZ7C or
equivalent).
NOTE: This spark ignition system meets all require-
ments of the Canadian Interference-Causing
Equipment Regulations.
D
Do not sand blast,
scrape or clean elec-
www.mymowerparts.com www.mymowerparts.com
A

CARBURETOR ADJUSTMENT

The carburetor was pre-set at the factory for optimum
performance. If further adjustments are necessary,
please take your unit to the nearest Authorized Service
Center listed in the Yellow Pages. Call 1-866-747-9816
for more information.

STORING A CHAIN SAW

CAUTION:
30 days without performing the following pro-
cedures.
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instructions
are followed, fuel remaining in the carburetor will evapo-
rate, leaving gum-like deposits. This could lead to diffi-
cult starting and result in costly repairs.
1. Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
2. Start the engine and let it run until the unit stops to
remove fuel from carburetor.
3. Allow the engine to cool (approx. 5 minutes).
4. Using a spark plug wrench, remove the spark plug.
5. Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several
times to coat internal components. Replace spark
plug (Fig. 40).
NOTE: Store the unit in a dry place and away from pos-
sible sources of ignition such as a furnace, gas
hot water heater, gas dryer, etc.
18
B
Fig. 39
Never store a chain
saw for longer than
Fig. 40